{"TOTAL":5000,"ITEMS":{"COLUMNS":["ITEM_TITLE","ITEM_LINK","ITEM_DESCRIPTION","ITEM_SOURCE","ITEM_DATE"],"DATA":[["How to save a large assembly without re-saving parts","https://forum.solidworks.com/thread/213135","I frequently end up copying large assemblies/ drawings to update 1 or 2 components and change the name. When I "save as" a new name, I get prompted to save EVERY SINGLE SUB COMPONENT. I don't want to do this and I don't want to have to click "save" or "cancel" hundreds of times when I copy a large assembly. Is there a way to avoid this?","Forums","1 hour ago"],["SolidWork Books?","https://forum.solidworks.com/thread/213632","SolidWork Books? I'm relatively new to Solidworks. I work with AutoCAD for a living but no 3D.","Forums","2 hours ago"],["how to mate concave wheels on rail","https://forum.solidworks.com/thread/217077","I have an assembly problem. How do I mate a series of concave wheels onto a round bar? I tried concentric and tangent. But those are not correct entities according to SolidWorks.","Forums","3 hours ago"],["I see the points are messed up again...","https://forum.solidworks.com/thread/214460","the point system isn't updating again andRichard Doyleis on vacation. Just my luck. I was hoping to catch up with Deepak today.","Forums","4 hours ago"],["Saving new files while working offline","https://forum.solidworks.com/thread/213216","I just had to spend some time recovering a situation when a colleague had inadvertantly started to work offline and had created a load of "phantom" parts. suppose you pdm vault view is at C:\\PDMstandard\\","Forums","9 hours ago"],["Is it possible to make one of the bodies in the model weightless?","https://forum.solidworks.com/thread/217091","A macro I'm writing needs to split a solid body into two, assign a heavier material to one of these bodies, and an ideally, a weightless material to the other body. By "weightless" I mean that it's density should be 0. That body must be visible, but by definition, it must not affect the Center of Mass of the model.","Forums","10 hours ago"],["BOM in .slddrw does not update after Pack & Go...Why?","https://forum.solidworks.com/thread/216800","I use Pack & Go to copy existing drawings & assemblies into a new project. I initiate the P&G command from the drawing environment. After the project is Packed & Gone, I open the new drawing and use File>Find References to confirm that the drawing is referencing only the models I want referenced (also to see that referenced files are named & stored appropriately..).","Forums","10 hours ago"],["Undo works like Rewind?","https://forum.solidworks.com/thread/99003","Undo works like Rewind? Well a new semester is about to start and I have a question about behavior I have seen happen to several students that I cannot reproduce.","Forums","15 hours ago"],["Joule Heating Tutorial","https://forum.solidworks.com/thread/57734","Joule Heating Tutorial Is there any tutorial for setting up a Joule heating simulation or does anybody have any tips? We have a need to run a study using it but I am not sure what inputs are required to start such a study.","Forums","15 hours ago"],["Capture 3D view not working in SW MBD 2018","https://forum.solidworks.com/thread/217059","I'm using SW MBD the first time and tried to capture a 3D view. After using the "Auto Dimension Scheme" and the "Show Tolerance Status" I get all the dimensions I want and my part is fully defined (Green) but when I click the "Capture 3D View" I don't get the 3D thumb nail next to the Capture 3D View" button.","Forums","17 hours ago"]]}}